Posts
242
Joined
2/1/2009
Location
Calgary
CA
Edited Date/Time
3/1/2015 8:48am
Had my KTM linkage on the workbench and greased it all up & then noticed a super thin steel shim/washer sitting there. I didn't remove it but it must have dropped out of wherever it came from.
Looking at the parts fiche it looks to me like #19 on the diagram - the size matches the spec in the parts fiche.
I'm curious why they would use a super thin washer on only one side and with 3 different thicknesses available (0.1,0.2 and 0.3 mm). What would that washer do and why only on one side?
Thoughts / ideas?
Looking at the parts fiche it looks to me like #19 on the diagram - the size matches the spec in the parts fiche.
I'm curious why they would use a super thin washer on only one side and with 3 different thicknesses available (0.1,0.2 and 0.3 mm). What would that washer do and why only on one side?
Thoughts / ideas?
Post a reply to: KTM Linkage - Thin Washer